Using Y-source network as a connector between turbine and network in the structure of variable speed wind turbine

Mahmoud Zadehbagheri, Tole Sutikno, Rahim Ildarabadi

Abstract


Environmental factors such as air pollution and increase in global warming by using polluting fuels are the most important reasons of using renewable and clean energy that runs in global community. Wind energy is one of the most suitable and widely used kind of renewable energy which had been in consideration so well. This paper introduces an electric power generation
system of wind based on Y-source and improved Y-source inverter to deliver optimal electrical power to the network. This new converter is from impedance source converters family. This presented converter has more degrees of freedom to adjust voltage gain and modulation. Also, by limiting the range of simultaneous control (shooting through) while it maintains the
highest power of maximizer, it can operate in higher modulation range. This causes the reduce of stress in switching and thus it will improve the quality of output. Recommended system had been simulated in MATLAB/Simulink and shown results indicate accurate functionality.

Keywords


PMSG; Power generation system; Renewable energy; Wind energy; Wind turbine; Y-source inverter; Y-source network

Full Text:

PDF


DOI: http://doi.org/10.11591/ijpeds.v12.i3.pp1644-1658

Refbacks



Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.