Electrical Discharge Machining Flyback Converter using UC3842 Current Mode PWM Controller

Nazriah Mahmud, Azli Yahya, Trias Andromeda

Abstract


This paper presents a current mode Pulse Width Modulation (PWM) controlled Flyback converter using UC3842 for Electrical Discharge Machining current generator control circuit. Circuit simplicity and high efficiency can be achieved by a Flyback converter with current mode PWM controller. The behaviors of the system's operation is analyzed and discussed by varying the load resistance. Matlab sofware is used to simulate the Flyback converter where a prototype has been built and tested to verify it's performance.

DOI: http://dx.doi.org/10.11591/ijpeds.v5i2.6680


Full Text:

PDF

Refbacks

  • There are currently no refbacks.


Copyright (c) 2014 Nazriah Mahmud, Azli Yahya, Trias Andromeda

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.